Description
Allows you to play your JAMMA games in your Sega Zaxxon, Congo Bongo or Super Spy cabinet. Games with up to 2 buttons are supported.
Images
Pinout
This adapter follows the following pinout scheme:
| SOLDER SIDE | PARTS SIDE |
|---|---|
| GND | GND |
| GND | GND |
| +5V | +5V |
| +5V | +5V |
| -5V | -5V |
| +12V | +12V |
| SPK- | SPK+ |
| COUNT1 | COUNT2 |
| COIN1 | COIN2 |
| RESET | SVC |
| P1START | P2START |
| P1LEFT | P1RIGHT |
| P1UP | P1DOWN |
| P1B1 | P1B2 |
| P2LEFT | P2RIGHT |
| P2UP | P2DOWN |
| P2B1 | P2B2 |
| GND | GND |
| VRED | VGREEN |
| VBLUE | VSYNC |
| GND | GND |
| GND | GND |
(Adapter edge connector facing away, list is ordered right to left)
Button and Switch Layout:
In most circumstances this adapter will work as intended with your cabinet without any modifications. Problems may occur in a modified cabinet, or with games that require more than 2 buttons and more than one coin switch present.
If the button order is wrong you may need to swap the wires going to the buttons behind the control panel.
If game can’t be coined up, say in a case where only COIN2 switch is wired in the cabinet, and the game only supports the COIN1 switch, you may need to swap the connections to the coin switches .
Compatible Cabinets
This is the list of compatible cabinets that can be used with this adapter:
Revision History:
Rev 1.0: Initial Design.
Specifications
Board Size: 45mm x 112mm
Current Carrying Capacity: 5V – 12A, 12V-3A