Description
Allows you to play your JAMMA game in a Sega Pengo pre-JAMMA game cabinet. This adapter supports JAMMA games with only one button.
Images
Pinout
This adapter follows the following pinout scheme:
| SOLDER SIDE | PARTS SIDE |
|---|---|
| GND | GND |
| GND | GND |
| +5V | +5V |
| +5V | +5V |
| +5V | +5V |
| P1B1 | COUNT2 |
| P2B1 | COUNT1 |
| COIN1 | COIN2 |
| TEST | SVC |
| P1START | P2START |
| P1LEFT | P1RIGHT |
| P1UP | P2UP |
| P2LEFT | P2RIGHT |
| NC | P1DOWN |
| GND | GND |
| VRED | VGREEN |
| VBLUE | VSYNC |
| P2DOWN | SPK+ |
| +12V | +12V |
| VOL* | VOL* |
| GND | GND |
| GND | GND |
(Adapter edge connector facing away, list is ordered right to left)
Important: This adapter does not support the -5V power rail which is not present in Sega Pengo cabinet’s wiring harness. Games that require -5V may not run.
Button and Switch Layout:
In most circumstances this adapter will work as intended with your cabinet without any modifications. Problems may occur in a modified cabinet, or with games that require more than one button, or use the -5V power rail.
Compatible Cabinets
This is the list of compatible game cabinets that can be used with this adapter:
Revision History:
Rev 1.0: Initial Design.
Specifications
Board Size: 45mm x 112mm
Current Carrying Capacity: 5V – 12A, 12V-3A