Description
Allows you to use your pre-JAMMA Sega System 1 and 2 games, in a JAMMA cabinet or a super gun device.
This 8-bit hardware predates System 16 boards and was used from about 1983 to 1987 not only by Sega but also other manufacturers such as CoreLand and Vic Tokai. System 1 boards are typically older and consist of a single PCB while System 2 boards are typically larger and consist of 2 PCBs stacked together. Both types share the same pinout and belong to a pinout class commonly known as Sega System 8.
Images
Pinout
This adapter follows the following pinout scheme:
| SOLDER SIDE | PARTS SIDE |
|---|---|
| GND | GND |
| GND | GND |
| +5V | +5V |
| +5V | +5V |
| COUNT2 | COUNT1 |
| NC | +12V |
| P2B3 | P1B3 |
| P2B1 | P1B1 |
| P2B2 | P1B2 |
| NC | NC |
| P2DOWN | P1DOWN |
| P2UP | P1UP |
| P2RIGHT | P1RIGHT |
| P2LEFT | P1LEFT |
| P1START | COIN1 |
| P2START | COIN2 |
| NC | TEST |
| NC | SVC |
| SPK- | SPK+ |
| VGREEN | VRED |
| VSYNC | VBLUE |
| GND | GND |
(PCB edge connector facing away, list is ordered right to left)
Compatible Games
This is the list of compatible games that can be used with this adapter:
- Regulus
- Spatter
- Choplifter
- My Hero
- Ninja Princess
- Pitfall II – The Lost Caverns
- Sega Ninja
- Seishun Scandal
- Calorie Vs. Moguranian
- Gigas *
- Gigas Mark II
- Transformer
- Wonder Boy
- Wonder Boy Deluxe
- Wonder Boy – Monster Land
- Global Defense
* The 36 pin version of Gigas with an additional connector for spinner controls will not work with this adapter.
The adapter has been tested with many genuine boards and bootlegs for compatibility.
Revision History:
Rev 1: Initial publicly available design.
Rev 1.2: Changes to board size and silkscreen to improve adapter identification.
Board Size: 47mm x 112mm
Current Carrying Capacity: 5V – 12A, 12V-3A