Description
Allows you to use your Flower PCB in a JAMMA cabinet or a super gun device.
Flower is a rare flower themed vertical shoot’em up running on a horizontal monitor. It was produced by Clarue and distrubuted by Komax in North America and Sega / Alpha Denshi in Japan.
This adapter works with the genuine version of Flower. Apparently a bootleg version of this rare game exists as well, but was not tested for compatibility.
Images
Pinout
This adapter follows the following pinout scheme:
| SOLDER SIDE | PARTS SIDE |
|---|---|
| GND | GND |
| GND | GND |
| +5V | +5V |
| +5V | +5V |
| +12V | +12V |
| SPK- | SPK+ |
| P1UP | P1DOWN |
| P1LEFT | P1RIGHT |
| P1B1 | P1B3 |
| P1B2 | NC |
| P2UP | P2DOWN |
| P2LEFT | P2RIGHT |
| P2B1 | P2B3 |
| P2B2 | NC |
| COIN1 | P1START |
| P2START | NC |
| NC | NC |
| COUNT1 | NC |
| VSYNC | VBLUE |
| VGREEN | VRED |
| GND | GND |
| GND | GND |
(PCB edge connector facing away, list is ordered right to left)
Important: The bootleg version of the game could not be tested.
Compatible Games
This is the list of compatible games that can be used with this adapter:
This adapter has been tested with a genuine Clarue Flower board for compatibility.
Revision History:
Rev 1.0: Initial Design.
Specifications
Board Size: 50mm x 112mm
Current Carrying Capacity: 5V – 12A, 12V-3A